Losing hot water is disruptive in a way few plumbing problems match. Whether your tank is leaking from a failed anode rod, your pilot won't stay lit, your electric element has burned out, or your tankless unit is flashing an error code โ Masters Plumbing Service's water heater techs in Lamar, SC arrive with diagnostic tools and replacement parts to resolve it in one visit.

We diagnose before we recommend. Many water heater calls in Lamar, SC result in a repair, not a replacement.
Component-level testing takes 10โ15 minutes and produces a clear diagnosis โ not a guess that leads to replacing the wrong part.
For tankless units, we stock igniter assemblies, flow sensors, and descaling supplies for the major brands common in Lamar homes.
We don't recommend replacement to sell a unit. We work through the math with you openly so the decision is yours.
Code compliance isn't just legal protection โ a missing expansion tank or improperly discharged T&P valve creates real risk. We install to code every time.
Our techs are trained on all major residential water heater types and brands. Here's how we approach each category.
Most common gas water heater repairs: failed thermocouple (pilot lights but won't stay on), faulty gas control valve, clogged burner orifice, failed thermopile, and depleted anode rod causing sulfur smell in hot water. We test the gas supply pressure at the unit, check thermocouple millivolt output with a meter, inspect the burner assembly, and confirm proper draft on the flue before recommending any repair.

A failed upper element causes loss of hot water entirely. A failed lower element produces hot water but in smaller volume. Knowing which symptom you're experiencing before we arrive helps us confirm the likely failure quickly on-site.
Scale buildup in the heat exchanger is the leading performance issue in tankless units in hard-water areas. We perform a citric acid descaling flush through the heat exchanger using flush kit ports โ restoring flow rate and heating efficiency without replacing the unit.
A T&P valve that drips constantly, won't reset after testing, or shows visible corrosion needs immediate replacement โ it's failing in the closed position, removing the safety protection it provides. We replace the valve with a listed unit rated for the tank's BTU input and install or verify the discharge piping before leaving.
The sacrificial anode rod โ typically magnesium or aluminum โ corrodes preferentially inside the tank, protecting the steel tank lining. When depleted, the tank wall begins corroding instead. Most anode rods last 4โ6 years; hard water or softener use accelerates depletion. Replacing the anode on a mid-life tank is the single best investment for extending water heater life.

When a tank is beyond economic repair โ internal corrosion, cracked tank shell, or a unit over 10โ12 years old with multiple failing components โ replacement is the right answer. We carry 30-, 40-, and 50-gallon gas and electric units on our trucks for same-day installation. We also perform tank-to-tankless conversions where the existing infrastructure supports it.
Here's what a Masters Plumbing Service water heater service call looks like in Lamar, SC.
Knowing the fuel type, tank size, and approximate age also helps pre-load relevant parts before leaving the shop.
The diagnosis tells you what failed and why โ not just that something is wrong.
No pressure tactics. If repair makes sense, we say repair. If the math favors replacement, we show you why.
You get hot water today, documentation of the completed work, and warranty terms in writing.
Gas water heater stopped heating on a Thursday evening. Masters Plumbing Service had a tech out Friday morning who tested the thermocouple โ millivolt output was at 12mV, well below the 25mV minimum. Replaced the thermocouple and pilot assembly in 45 minutes. Total cost was under $200 and the tech told me the price before touching anything. No upsell attempt at all.
{Electric water heater wouldn't recover โ 10 minutes of hot water then cold. Masters Plumbing Service's tech identified the lower heating element had failed, drained the tank, replaced the element and lower thermostat while he was in there, and restored full recovery capacity. Explained the difference between upper and lower element function which I'd never understood.|T&P valve dripping continuously. Tech identified it wasn't just thermal expansion but a valve that had corroded open. Replaced the valve, re-routed the discharge pipe to code, verified tank pressure was in normal range. All in under 2 hours.}
Tankless Navien unit throwing error code 027 โ heat exchanger overtemp. Tech explained that's almost always scale buildup restricting flow. Performed a citric acid descaling flush through the service ports, restored normal flow. Unit's been running clean ever since. Much cheaper than I expected and no replacement needed.

Masters Plumbing Service dispatches water heater technicians across Lamar and the surrounding Lamar, SC service area. Same-day service is available for most repair calls โ call to check today's availability.
Our techs are familiar with the specific water chemistry and pressure conditions in Lamar, which directly affects water heater component life and maintenance needs.

Our water heater techs are in Lamar today with the parts to fix most units same-visit. Gas, electric, tankless โ we diagnose before we quote, and quote before we start.
๐ Call +1-844-833-0201 Now